LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
Posts: 2
Joined: Wed Dec 19, 2012 11:21 am
Allin1DC CNC Controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: A900243


Post by GI2012 » Wed Dec 19, 2012 11:27 am

i am working with CENTROID CNC software CNC11 and with MP11 and GPIO4D my problems are when i activate the enable the motor turns and an alarm occured differential encoder fault i have disabled it and after that i run the auto tune and i have the X axis ok for autotune and the other they have problem of friction and i don't know what to do realy i wanna to perform an other auto tune but when i do it the z motor jumps and i have 410 alarm for y axis i hope i will get so help for that and tahnik you very much.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest