Rackmount Tool Change Example
Moderator: cnckeith
-
- Posts: 428
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Rackmount Tool Change Example
Attached are samples of an M6 that performs rackmount tool changes as well as the associated PLC program. PLC involvement is minimal in typical rackmount systems with the PLC only being used to turn on and off the tool unclamp output although in some cases the PLC also needs to turn on an output to open a cover, pull up the dustfoot etc...
- Attachments
-
- rackmountm6.txt
- (4.75 KiB) Downloaded 271 times
-
- allin1dc-rack.txt
- (95.37 KiB) Downloaded 267 times
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)