Rackmount Tool Change Example

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
Centroid_Liviu
Posts: 428
Joined: Mon Jul 18, 2011 9:57 am
Allin1DC CNC Controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes

Rackmount Tool Change Example

Post by Centroid_Liviu »

Attached are samples of an M6 that performs rackmount tool changes as well as the associated PLC program. PLC involvement is minimal in typical rackmount systems with the PLC only being used to turn on and off the tool unclamp output although in some cases the PLC also needs to turn on an output to open a cover, pull up the dustfoot etc...
Attachments
rackmountm6.txt
(4.75 KiB) Downloaded 271 times
allin1dc-rack.txt
(95.37 KiB) Downloaded 267 times
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043

Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.

(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Post Reply