230 vac transformer for dc supply

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
Ajax
Posts: 7
Joined: Thu Apr 01, 2010 7:26 am
Allin1DC CNC Controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: Yes
CNC11: No
CPU10 or CPU7: No
System Serial Number: can't access serial no. until
software is installed. Soon.
Location: seattle

230 vac transformer for dc supply

Post by Ajax » Mon Oct 04, 2010 8:10 am

I,m looking for a wiring diagram showing the 230 volt transformer. I,m cautious because I have 240 at the primary and am getting 90vac at the secondary between 1 leg and the center tap. This gives me 130vdc after the bridge. I'm only using it for servo dc supply for the ALLIN1. Also except for verifying the transformer connection I have completed the physical install of the ALLIN1 system. I would like to verify what manual I should be using to start the system up with. I didn't see one that says it is for the ALLIN1.

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests