RE: CLOSE LOOP MOTOR MOVES ONLY IN ONE DIRECTION

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Orukoh Jaramogi
Posts: 12
Joined: Fri Feb 16, 2018 9:31 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No

Re: RE: CLOSE LOOP MOTOR MOVES ONLY IN ONE DIRECTION

Post by Orukoh Jaramogi »

Dave_C wrote: Fri Feb 16, 2018 10:47 pm Ok, Looking at the picture there is no Limit switch connections to this drive but there is a USB port. Having used similar leadshine drives I have connected the special cable and checked to see how the drive was programmed.

http://www.yankong.com/EN/proview-54-23.html

I went to this site and looked up your controller.

If switch 1 is set to "ON" the motor will only turn clockwise!

Set switch 1 to "off" for Pulse and direction.

Dave C.

Thank you Dave. You are heaven sent. It has worked perfectly... I don't know how I managed to overlook that.
Orukoh Jaramogi
Posts: 12
Joined: Fri Feb 16, 2018 9:31 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No

Re: RE: CLOSE LOOP MOTOR MOVES ONLY IN ONE DIRECTION

Post by Orukoh Jaramogi »

Dave_C wrote: Fri Feb 16, 2018 10:47 pm Ok, Looking at the picture there is no Limit switch connections to this drive but there is a USB port. Having used similar leadshine drives I have connected the special cable and checked to see how the drive was programmed.

http://www.yankong.com/EN/proview-54-23.html

I went to this site and looked up your controller.

If switch 1 is set to "ON" the motor will only turn clockwise!

Set switch 1 to "off" for Pulse and direction.

Dave C.


Hello. Dave C.
I really appreciate the help here.

I would like to call you personally to a different problem where you may help point out something I am overlooking again. Here is the thread viewtopic.php?f=20&t=1542.

Thank you in advance. :)
Post Reply