Re-running System Test CNC11

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
tblough
Posts: 115
Joined: Tue Mar 22, 2016 10:03 am
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: 100505
100327
102696
Location: Boston, MA
Contact:

Re-running System Test CNC11

Post by tblough » Fri Jan 05, 2018 5:27 pm

How do you run the system test again if it has previously been completed on a control?
Cheers,

Tom
Confidence is the feeling you have before you fully understand the situation.

cncsnw
Posts: 342
Joined: Wed Mar 24, 2010 5:48 pm

Re: Re-running System Test CNC11

Post by cncsnw » Fri Jan 05, 2018 10:10 pm

F1/Setup -> F3/Config -> F5/Test ?

tblough
Posts: 115
Joined: Tue Mar 22, 2016 10:03 am
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: 100505
100327
102696
Location: Boston, MA
Contact:

Re: Re-running System Test CNC11

Post by tblough » Sat Jan 06, 2018 11:27 am

Nope. Goes away after test has been run
IMG_20180106_102436.jpg
Cheers,

Tom
Confidence is the feeling you have before you fully understand the situation.

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests