Cutter comp problems
Moderator: cnckeith
-
BrentLidgard
- Posts: 17
- Joined: Thu May 13, 2010 12:19 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: No
Cutter comp problems
I have been writing a simple program and am having serious problems with the cutter comp. I followed the directions that are in the manual and it does the wierd moves no matter what I do. I wrote the same exact program in the mill demo and it does not do the same wierd moves. Has anyone else had these problems or am I the one to blame. I have updated to the most current version of the software but it is no help.
-
CNCguy
- Posts: 28
- Joined: Tue Mar 23, 2010 8:54 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Pennsylvania
Re: Cutter comp problems
Are you running Mach or Centroid software?
Can you post a short section of your program , narrowed down to a few lines before and after the offending G-codes?
Can you post a short section of your program , narrowed down to a few lines before and after the offending G-codes?