Page 1 of 1

Run Time Graphics

Posted: Tue Dec 19, 2017 6:17 am
by danny
Hello !
Im Just doing the last finishing touches on my mazak lathe retrofit with oak board and i ran a small program to test the machine .
All looks great but the run time graphics come up as they should but its not showing the Trail , i tried F9 on and off but no change !!
Any ideas anyone ?

Thanks

Re: Run Time Graphics

Posted: Tue Dec 19, 2017 10:09 am
by cnckeith
zero tool diameter?

Re: Run Time Graphics

Posted: Sat Apr 20, 2019 9:21 pm
by wellington_tregear
Old thread, I know. But for future readers, here is additional info.

I too had this problem of no trail being shown (but it did show recently, before a centroid software update). Keith's comment made me realize that I did not have a tool specified at all in the gcode. It was hastily written test code and no tool was called out. Simply adding "t1" in the code made trail show (which does have a dia in the tool table).