Run Time Graphics

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
danny
Posts: 14
Joined: Thu May 22, 2014 4:51 am
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: 0329160186
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No

Run Time Graphics

Post by danny »

Hello !
Im Just doing the last finishing touches on my mazak lathe retrofit with oak board and i ran a small program to test the machine .
All looks great but the run time graphics come up as they should but its not showing the Trail , i tried F9 on and off but no change !!
Any ideas anyone ?

Thanks
cnckeith
Posts: 7165
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:

Re: Run Time Graphics

Post by cnckeith »

zero tool diameter?
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
wellington_tregear
Posts: 15
Joined: Sat Feb 09, 2019 10:13 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Location: Monroe Michigan USA

Re: Run Time Graphics

Post by wellington_tregear »

Old thread, I know. But for future readers, here is additional info.

I too had this problem of no trail being shown (but it did show recently, before a centroid software update). Keith's comment made me realize that I did not have a tool specified at all in the gcode. It was hastily written test code and no tool was called out. Simply adding "t1" in the code made trail show (which does have a dia in the tool table).
Post Reply