OAK Enable Axis

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
tblough
Posts: 131
Joined: Tue Mar 22, 2016 10:03 am
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: 100505
100327
102696
Location: Boston, MA
Contact:

OAK Enable Axis

Post by tblough » Mon Dec 18, 2017 11:37 am

I'm trying to commission my drives on my lathe conversion and before I broke out the jumper wires to turn on the drive enable, I was wondering if there was an output bit or memory location I can force from the I/O panel in CNC11v3.16 to turn on the drive enable for Axis 1 and Axis 2?

Thanks,

Tom
Cheers,

Tom
Confidence is the feeling you have before you fully understand the situation.

Centroid_Tech
Posts: 156
Joined: Thu Mar 18, 2010 2:24 pm

Re: OAK Enable Axis

Post by Centroid_Tech » Mon Dec 18, 2017 6:01 pm

Unfortunately, the PLC program doesn't control those outputs so there is no way to force them. They are handled by the CNC11 software. You should just be able to press F3(MDI). That will energize all of your axes. If you don't have things wired in such as axis encoders or fault signal or etc. which will put the Centroid control in a fault state, you should be able to disable stall detection. From the main screen press F1(Setup)->F3(Config)->default value is 137->F4(PID). Press CTRL+V. You should see a message telling you that stall detection has been disabled underneath the message window. Then you can press F3(MDI).

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest