Are the +24V, and +24V Return connections on Spindle Analog Out connector only used for the analog spindle I/O? I'm wondering if it would be better to bring these over from my VFD instead of the Oak power supply.
Thanks,
Tom
OAK 24V Connections
Moderator: cnckeith
-
- Posts: 3101
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
OAK 24V Connections
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Re: OAK 24V Connections
The 24VDC on that header is for Servo drive I/O.
If you look at your schematic, you'll see that the voltage (or common depending on whether your VFD is setup for sourcing or sinking) for your spindle drive I/O DOES come from the spindle drive and is routed through the Spindle Enable, Spindle Direction, Reset outputs and to the SpindleInverterOk input.
If you look at your schematic, you'll see that the voltage (or common depending on whether your VFD is setup for sourcing or sinking) for your spindle drive I/O DOES come from the spindle drive and is routed through the Spindle Enable, Spindle Direction, Reset outputs and to the SpindleInverterOk input.
-
- Posts: 3101
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: OAK 24V Connections
Scott,
I am using the drives 24V for the digital I/O - Spindle Enable, Spindle Direction, Reset outputs and to the SpindleInverterOk. That's what got me to wondering if I needed to do the same thing for the two analog signals to/from the drive.
For what it's worth, I've attached the schematic I came up with for my machine.
I am using the drives 24V for the digital I/O - Spindle Enable, Spindle Direction, Reset outputs and to the SpindleInverterOk. That's what got me to wondering if I needed to do the same thing for the two analog signals to/from the drive.
For what it's worth, I've attached the schematic I came up with for my machine.
- Attachments
-
- Hardinge Centroid HLV-H10140T.pdf
- (460.13 KiB) Downloaded 105 times
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.