DC servo compatible


LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
Posts: 6
Joined: Wed Oct 25, 2017 6:17 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
CNC11: No
CPU10 or CPU7: No
System Serial Number: none

DC servo compatible

Post by Dennis23t » Thu Oct 26, 2017 12:50 pm

I am seriously wanting to update my mhp mill. Will this motor work with the all in one.

Posts: 602
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: none

Re: DC servo compatible

Post by cnckeith » Thu Oct 26, 2017 5:42 pm

Hello. well the allin1dc can run a motor of that size.. but with the brushes out (seen in photo) I would not reuse that motor unless it was rebuilt by a qualified servo motor repair shop.

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests