**RESOLVED** Doesn't Detect Ajax Hardware

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Locked
dawizard
Posts: 20
Joined: Fri Jun 18, 2010 3:05 pm

**RESOLVED** Doesn't Detect Ajax Hardware

Post by dawizard »

I do not get the message Ajax hardware has been detected until i click on Config plugins. Then it will display.
I disabled the limit dip switches and jumpered the e stop.
In the diagnostic screen none of the Enable signals are lit up
If I press reset the message is the e-stop is pressed. the led on the mpu11 that reads DSP debug is flashing Green.
Any Idea what went wrong?
diycncscott

Re: Doesn't Detect Ajax Hardware

Post by diycncscott »

Hello,

Make sure you are running the Mach from the "Mach Ajax Plugin" shortcut that the plug-in installer placed on your desktop.

The DSP Debug LED is supposed to flash. The manual had a typo and has been corrected. Please download the new manual at:
http://www.ajaxcnc.com/ajaxbb/viewtopic.php?f=20&t=76
Locked