Centroid Community CNC Support Forum

I have a PC control I bought new in 2007 replaced with a new one all in one m440 console in 2017. My old m40 consoled keyword was starting to stop working. It is a complete unit for 4th axis. I am including the manual in the pithos. I pad close to $4000 for it on 07. asking $1500 It has the unlock f...

I was able to get the bards pressed together and the date set!!!

Thank you for all the help!!!

Regards,
Travis

Thank for the help, I have taken it apart further to have better access. I have attached a photo. I have inspected and am sure I have the pins in the proper place. my concern I have now is are the pins in far enough? You can tell that there is some taper to the socket. When I first removed the bard ...

T15 CS# 8121 no can not get report
Hello I just replaced the battery on my mother bard it was a very fun process.

I now get at powerup Error initializing Servo card
Then Error occurred sending line 54
Then the machine stops.

Any help would be great on fixing this!!

Thank you in advance,
Travis

I did the test and it seems the VFD is throwing the Spindle Fault. even though it dose not show a fault on its display. I put the jumper between 6 & 7 H9 powered up the machine and it did not fault. After some time I powered down the machine cut the jumper. restarted it and before I could get th...

Thank you! I believe it is a MPU11. The power supply is fairly new I had this issue before the new power supply was installed. I will look into the terminal blocks again. We went three them before as hade an issue with our lathe the wires were crimped on the plastic insolation. I have attached some ...

Hello again, To further the story I sent in the PLS and Teck found no problems with it. They did update the power supply and did charge a reasonable price ( less than was expecting). but it did not fix the issue!!! this s a intermittent problem that happens more when it is cold??? I am a small job s...

Thank you for the help!!!!

Hello,

I was wondering what is the right way to change the small nickel size battery on my T15 control #8121?
What might be the replacement# for that?
Should I replace it with the control on so no data will be lost?

Thank you,

Great thank you!!

It was in Intercon went to a cycle then F2 Tool then I could edit the individual tools severity.

Thank you!!!