Centroid Community CNC Support Forum

Thanks for getting us the discount..

I think that sometimes using this would be a good way to show what you are asking a question about or what you're trying to explain.

Orin

Was that toroidal power supply not suitable to reuse? Not a simple re-use - Would have to be completely modified as a lot of the electronics were on the main controllers circuit board. Because of the value of the Isel controller it was a better decision to leave it intact and list it on eBay. What ...

I was trying to get more familiar with CNC12 and noticed the DRO readings were not as I expected. Here is the CNC Wizard Axis Configuration page showing how I set the mm/turn. It's set to 4 mm as that is the spec on the ball screws in the Techno-Isel router that I'm upgrading to ACORN. http://www.au...

frijoli wrote: ↑Sun Oct 22, 2017 8:27 am What was the large toroidal supply in the early photo?

The power supply that was originally supplied with the router.

Are you going to use the original power supply for the motors? No The large power supply in the photo is a Mean Well LRS-350-24 that will supply 24 VDC for the stepper motors. The smaller supply is a Mean Well RD-35B which will supply 24 VDC for the ACORN logic and 5 VDC for the stepper driver cont...

Finally got time to start the Acorn installation into my Techno-Isel router and here are some photo of the progress to date: Here is the original controller and the mounting area after it was removed: http://www.autochart.com/ISEL/IMG_0441.JPG http://www.autochart.com/ISEL/IMG_0444.JPG After removin...

martyscncgarage wrote: ↑Fri Oct 20, 2017 11:23 pm
Stupid phone!
I fixed it ?

Stuff happens -

martyscncgarage wrote: ↑Fri Oct 20, 2017 10:26 pm Oring

Really?? Guess I have everything sealed - And yes, Greensboro, NC is on the east coast.

I just ordered one and the best they would do was $85 plus their shipping charge of $27.47 for a total of $112.47.

Marty,

Do you know what offer amount they took?

Orin