Centroid Community CNC Support Forum

Thank you.
Your detailed instructions worked.
Spindle brake now works brake release with m3, m4 comands. m5 = brake activates (spindle stop).

I am at the point of getting brake working on new installation of allin1. I have 24vdc solinoids for air supply to little cylinder. What i have happining so far: when pc is powered up and allin1 prg loadsup, CNT1 energizes and brake solinoid activates -air pressure to cylinder,- cylinder rod extends...

Thank you,,
That makes sense.
Displayed ipm is a combined total from all axes moving at that time.

"Rapid" moves, what setting determines how fast the rapid is? Allin1 MPU11 I have max speed rate set to 150ipm, however when doing a MDI rapid move, i see the main screen display going up to ~200ipm (displayed to the right of DRO). Does parameters 357-364 "max rpm" effect Rapid i...

Problem solved Mario found the problem, a parameter that i set incorrectly. Back to all drives working again!!
the error msg is now gone as well.
Thank you!!

New install allin1. All axes were working fine, could home the machine, all was fine for the past few days.. Observations: Previously occasionally when i tried to jog x axes, i would have to push the left or right arrow key twice before it would move. I have a 412 MPG1 encoder error that has always ...

I switched kd to 3 all axis.
Much quieter now, still a little humming.

That worked. Motors now lock up. No error, mdi command line moves each axis and displays movement on DRO for each. reversing motor leads did the trick. Thank you!!! When I "esc" mdi mode back to main menu. after about 1 minute motors drop out and display "x y z idling too high: Releas...

I am currently at the stage of chapter (6) 6.3 "Motor Software Setup" in manual. Using Alt + J for control. Feed-rate set to 10% Drive belts all removed from motors. Each axis motor tested one at a time. Each motor has the same response when i try to move. Axis motor spins up quickly then ...