Search found 286 matches

by Centroid_Tech
Thu Jun 14, 2018 9:09 am
Forum: Centroid Acorn CNC Controller
Topic: custom macro help (Resolved)
Replies: 20
Views: 7890

Re: custom macro help

The logic that I have written works as I just tested it. The only difference is that I did not have the # symbol when defining the input after the P designator.
by Centroid_Tech
Thu Jun 14, 2018 8:58 am
Forum: Centroid Acorn CNC Controller
Topic: Thermwood C53 5x10 Retrofit
Replies: 18
Views: 6851

Re: Thermwood C53 5x10 Retrofit

The cncm.hom file in the report that you attached has no logic in it to square the table. What's odd is that there is logic in that file that sets certain local variables but the variables aren't used anywhere in that file. I would recommend starting with the cncm.hom file that cnckeith posted which...
by Centroid_Tech
Wed Jun 13, 2018 2:51 pm
Forum: Centroid Acorn CNC Controller
Topic: ATC Macro / PLC Help please <success!>
Replies: 85
Views: 45029

Re: ATC Macro / PLC Help please <success!>

Unfortunately, there isn't. The only way around this issue that I can think of is the way that you have already determined using the M0.
by Centroid_Tech
Wed Jun 13, 2018 2:47 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: another schematic please
Replies: 3
Views: 2331

Re: another schematic please

Sorry about that. I can't find a schematic that shipped out with that particular PLC program but you should be able to use the attached schematic as a guide.
by Centroid_Tech
Wed Jun 13, 2018 12:57 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: another schematic please
Replies: 3
Views: 2331

Re: another schematic please

Here is the schematic associated with that PLC program.
by Centroid_Tech
Wed Jun 13, 2018 12:46 pm
Forum: Centroid Acorn CNC Controller
Topic: custom macro help (Resolved)
Replies: 20
Views: 7890

Re: custom macro help

I apologize. I didn't read your first post properly. I believe that if you switch that input back to being NC in the wizard, it should work.
by Centroid_Tech
Wed Jun 13, 2018 12:34 pm
Forum: Centroid Acorn CNC Controller
Topic: ATC Macro / PLC Help please <success!>
Replies: 85
Views: 45029

Re: ATC Macro / PLC Help please <success!>

Our software department is looking into this. In the meantime, it appears that you have found a workaround by adding an M0.
by Centroid_Tech
Tue Jun 12, 2018 1:37 pm
Forum: Centroid Acorn CNC Controller
Topic: custom macro help (Resolved)
Replies: 20
Views: 7890

Re: custom macro help

It appears that diycncscott got the P values reversed. When the P value is positive, the control is looking for the switch to open and when the P value is negative, the control is looking for the switch to close. Based on your original requirements, the M105/M106 logic in your program as well as the...
by Centroid_Tech
Tue Jun 12, 2018 1:21 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Schematic
Replies: 2
Views: 2007

Re: Schematic

Here is the schematic that goes with that PLC program.