Centroid Community CNC Support Forum

so you don't have to fiddle for hours and hours to get two switches to trip perfectly on square. just get them to hit in the ball park and then use software to fine tune it in. software adjustment is in the Wizard and covered in the manual square distance.png once you get the home program running , ...

MPG overrides the VCP. turn the WMPG knob to OFF to use the fast slow buttons on the VCP

draft Wizard USB-BOB setup page. supports 1 or 2 USB-BOB's connected to the CNCPC

Comments and suggestions welcome.

what 'canned' button functions would you like on the list?
draft updated 2-28-24

i'm told they will work together.

do you have a wmpg?

; ICN_PATH = C:\intercon\g43.icn ; --- Header --- N0001 ; CNC code generated by Intercon v5.09 BETA, Rev 4 ; Description: ; Programmer: ; Date: 27-Feb-2024 M25 G49 ; Goto Z home, cancel tool length offset G17 G40 ; Setup for XY plane, no cutter comp G21 ; millimeter measurements G80 ; Cancel canned ...

Leadshine, Teknic, Yaskawa, Delta, Sureservo software auto tune works well cheap china ac drives often has poor supporting software or it looks like they have auto tune but they really don't. i've had to hand tune a few and it took all day, certainly not worth trying to save a few bucks and then was...

just don't use the slave input. and yep you can wire all home switches into one input.
fyi...some NC prox switches do not like to be wired this way.

a new input that is available to use in this way since that manual was written is "HomeLimitAll"

cnckeith; I have the Teknic SDSK_RLN motors in the router on all axis ( X,Y,Z ) is there a specific motor from Teknics for the rotary A Axis that I should buy I have seen one tread that the person was not using the RLN line and used the EQN line instead. i always recommend the higher resolution cle...

Thanks! So if I put them back they should hold unless the auto-square macro is interrupted? This isn't so bad. I can just re-enter them if it happens. Not ideal, but not so bad. that is correct. usually once you get by the setup phase of commissioning the machine, this never happens. but just in ca...