Centroid Community CNC Support Forum

Gerald,

Can you generate a report (from the main menu F7-Utilities, F7-Report) and send the report.zip to tech@ajaxcnc.com. It will allow us to see what your settings and parameters are set to.

Please send tech support (tech@ajaxcnc.com) a current report of your system. To generate a report, from the main menu, press F7-Utilities, then F7-Report and choose where to save the report. We would just need the report.zip created.

Installing a VFD will also give you exact RPM speed control. Based on the model BP you have, the hp of your spindle motor is around 2-3hp?

Can you send us a report of your system? That will allow us to see what your parameter settings are as well as see exactly what hardware you are using. From the main menu press F7-Utilities, then F7-Report, it will then ask you for a location to save it to. We just need the report.zip generated. Ple...

Please see the attached schematic for wiring between the GS2 and ALLIN1DC.

It sounds as though your PC is not booting. I expect the reason is that the CMOS battery died. It's easy enough to boot, you just need to short the power pins on the Motherboard. Unfortunately, our records don't show what Motherboard is installed in that system or I could provide documents that deta...

TECH SUPPORT From the main screen press ALT+I to bring up the PLC Diagnostic menu. Manually trip the Y limit switches and verify that input 10 changes state when you trip the positive limit switch and input 9 changes state when you trip the negative limit switch. You can press ALT+I again to get rid...

The ALLIN1DC will only work with differential quadrature encoders. An in-depth description of the wires and signals can be found here : http://www.ajaxcnc.com/ajaxbb/viewtopic.php?f=20&t=4 . We have 2000 Line differential quadrature encoders available in several hollow shaft sizes that can be in...

We try to post the results whenever possible.

This tread addresses the same issue with several troubleshooting steps (though in that case the issue was hardware).
http://www.ajaxcnc.com/ajaxbb/viewtopic ... 9023#p2105

Rppman,

Are you referring to the automatic tool length measurement? If you email us a your system serial number (sales@ajaxcnc.com) or a report from your system, I can take a look at all the options purchased with your system.