Centroid Community CNC Support Forum

Those are original to the machine as shipped from Syil. Automationdirect.com sells some good couplings For example: https://www.automationdirect.com/adc/shopping/catalog/power_transmission_(mechanical)/drive_couplings/sim_drive_couplings/servo_high_gain_couplings/shr-55c-24-24 Do you have a build th...

tuffduck wrote: ↑Mon Jan 17, 2022 11:44 pm There aren't any. I have it wired like drawing S15117.
Contactor:
https://www.ebay.ca/itm/303348917509

You also used L4? (NO)
Doing this from my phone so don't have access to the drawing you referenced until the morning...

tuffduck wrote: ↑Mon Jan 17, 2022 11:02 pm Marty,
Where did you get the coupling that is in your video? Thanks

Which coupling are you referring to? Which video at what time in the video....been awhile since I did that series....

Marty

tuffduck wrote: ↑Mon Jan 17, 2022 10:37 pm Do you have a diagram?

Use a spare set of contacts on your Estop contactor. You would wire them to No Fault on C86ACCP
When the Estop contactor closes, it will close the input on C86ACCP

Marty

Not sure what your picture signifies. ("AIR feed goes here) There is an AIR BLAST that goes THROUGH the spindle to clear chips off tool shanks during a tool change. There is an AIR CURTAIN feature on some VMC's that blow air through the spindle cartridge to keep the bearings clear of fluids and...

Bridgeport BOSS w/ DC3IO CNC10 Mill Linux 1.51 I am looking to recover the configuration settings from a CF card using a CF to USB adapter and a alternate Windows PC, as the onboard computer is no longer functioning and cannot be replaced. I am not very familiar with Linux, so I would appreciate a ...

IF you swap the PC out, from a known good one from another machine, make sure both machines are running the same version of CNC12. Make sure you get FRESH reports from both machines and put them on a USB stick. Back up the CNCM directories from both machines as well. Make sure you know which is whic...

Thanks it arrived yesterday I unpacked it but got no further. If another user successfully used the laser you got, best you get with him and ask for a schematic. When user's successfully test and get a new laser going, its always nice that they post a fresh report and a schematic as to how they hoo...

You posted a page 3 of a schematic which I did not see earlier. It shows a "Rotary Switch" with 8 positions.
Kind of need to know what this is exactly. Have you removed the cover of the turret to show these electronics?

Marty

ALWAYS, ALWAYS, ALWAYS Post a fresh report when asking for help.
We can take a look at the settings and give you suggestions.

Marty