Search found 17 matches
- Mon Jan 08, 2018 8:25 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Continuation of my spindle and C axis quest: Dilemma
- Replies: 23
- Views: 7182
Re: Continuation of my spindle and C axis quest: Dilemma
Try this and see if it helps.
- Mon Jan 08, 2018 8:16 pm
- Forum: Centroid Acorn CNC Controller
- Topic: DMM AC servo spindle and C axis. Parts ordered!
- Replies: 37
- Views: 12546
Re: DMM AC servo spindle and C axis. Parts ordered!
Tis is what i used on the Masso for spindle and forward reverse it might help you with the wiring.
- Mon Jan 08, 2018 7:15 pm
- Forum: Centroid Acorn CNC Controller
- Topic: DMM AC servo spindle and C axis. Parts ordered!
- Replies: 37
- Views: 12546
Re: DMM AC servo spindle and C axis. Parts ordered!
Not sure why it rotated that pick sorry .
- Mon Jan 08, 2018 7:14 pm
- Forum: Centroid Acorn CNC Controller
- Topic: DMM AC servo spindle and C axis. Parts ordered!
- Replies: 37
- Views: 12546
Re: DMM AC servo spindle and C axis. Parts ordered!
Here is a picture ,i can send you a better one if you Pm me with Your Email, everything is mounted on a old tooling plate that i had, BIG HEAT SINK. And it has a polycarb clear case that fits over it all . At the top left is the voltage transformer bottom left resistor for braking ,and two solid sta...
- Fri Jan 05, 2018 4:00 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Encoder Basics
- Replies: 66
- Views: 178560
Re: Encoder Basics
Thanks for the reply Clay
- Thu Jan 04, 2018 11:45 pm
- Forum: Centroid Acorn CNC Controller
- Topic: DMM AC servo spindle and C axis. Parts ordered!
- Replies: 37
- Views: 12546
Re: DMM AC servo spindle and C axis. Parts ordered!
I already have a 1.8kw Dmm servo running as a spindle ,i am just converting from the masso to the Acorn ,i run it 1;1 motor to spindle with a timing belt. There is a limitation on the bottom end of 100 rpm minimum other wise i can hog steel no problem i have not been able to get top speed above 1850...
- Tue Jan 02, 2018 2:11 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Encoder Basics
- Replies: 66
- Views: 178560
Re: Encoder Basics
Hi all ,i have a 16 bit encoder differential driver receiver it says on my servo motor for my spindle ,with A+A-,B+B-,Z+Z- it is a 1.8kw servo motor from DMM tech that i use on my lathe .
I was wondering if it would interface with the Acorn board ?
I was wondering if it would interface with the Acorn board ?