Search found 91 matches

by bloomingtonmike
Sun May 18, 2014 9:08 pm
Forum: Centroid Community CNC Support Forum
Topic: offline centroid programming
Replies: 1
Views: 667

Re: offline centroid programming

Request the USB key.
by bloomingtonmike
Thu May 08, 2014 1:39 am
Forum: Centroid Community CNC Support Forum
Topic: Can I Add, and how: a functional geometry wear table option?
Replies: 2
Views: 730

Re: Can I Add, and how: a functional geometry wear table opt

Why not create a second tool adding the additional test diameter to the tool definition?
by bloomingtonmike
Sun Apr 27, 2014 8:06 pm
Forum: Centroid Community CNC Support Forum
Topic: AJAX CONTROL CHANGE OVER
Replies: 4
Views: 1057

Re: AJAX CONTROL CHANGE OVER

Check the amperage setting for the drive inputs (the pins have a range). Once you verify those are right make sure to run the tuning.

More Knowledgeable people than I will reply tomorrow :)
by bloomingtonmike
Fri Apr 25, 2014 9:25 pm
Forum: Centroid Community CNC Support Forum
Topic: Ajax reverse tapping cycle
Replies: 6
Views: 1486

Re: Ajax reverse tapping cycle

OK I have a ER32 floating tapping head now and the DC regen res installed for braking my VFD.

Is there a formula or table for figuring out good speeds for taps? 1/4-20, 1/2-13. 4-40, 8-32, 10 - those are the sizes I use the most.

Any advice on using the floating tapping heads?
by bloomingtonmike
Sun Apr 06, 2014 11:08 am
Forum: Centroid Community CNC Support Forum
Topic: GS2-XXXX ALLIN1DC
Replies: 4
Views: 934

Re: GS2-XXXX ALLIN1DC

Would it help to see the Hitachi WJ200 2.2kw connections to the AllInOneDC?
by bloomingtonmike
Thu Mar 27, 2014 1:28 pm
Forum: Centroid Community CNC Support Forum
Topic: Picture of DC1 installed on AllinOne
Replies: 1
Views: 765

Picture of DC1 installed on AllinOne

Is there an actual picture that shows a DC1 installed on a AllinOneDC out there anyone has seen? Planning my install and wonding where the standoffs get mounted to on the controller.
by bloomingtonmike
Thu Mar 27, 2014 9:59 am
Forum: Centroid Community CNC Support Forum
Topic: Good nema23 dc servo motor and encoder recomendation
Replies: 1
Views: 629

Good nema23 dc servo motor and encoder recomendation

Can anyone recommend a good nema 23 dc servo motor and encoder? I am wanting to try a cheaper 4th axis setup and will most likely go chinese and many use nema 23 motors. What do folks recommend?
by bloomingtonmike
Mon Mar 24, 2014 1:36 pm
Forum: Centroid Community CNC Support Forum
Topic: Ajax reverse tapping cycle
Replies: 6
Views: 1486

Re: Ajax reverse tapping cycle

I need to get the speed of my reverse faster then on my VFD. What speeds start and stop do you recommend for that?
by bloomingtonmike
Mon Mar 24, 2014 10:54 am
Forum: Centroid Community CNC Support Forum
Topic: Ajax reverse tapping cycle
Replies: 6
Views: 1486

Re: Ajax reverse tapping cycle

I only have centroid running. Ended up buying the full license. Need to change my profile.

Eventually I will have both setup.

Mark that as a recommendation for a future update.