Centroid Community CNC Support Forum

If a tool is ok for your jobs, do not change it

IMHO the only logical reason for other tools is if they give you an advantage in cost, speed or precision if one of them is at the moment nok.

With wine discard logic

Uwe

That is because the conture is not closed, not all points are connected.

Uwe

i updated TB1 "out of round circles/arcs" https://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/1.pdf 👍 From my experience, you can have nearly perfect round cutting with 0.04mm backlash, if corrected and setup ok, but anything over 0.01 mechanically would show up on the surfac...

I have the Z-Finder from Sorotec, the 3D Finder is better than probes for < 200 bucks, but I have only tested this one from a friend https://www.sorotec.de/shop/3D-Finder---3D-Measuring-sensor-6411-9688.html It is not featuring an angular adjustment, but a good radial adjustment. Kind of soft spring...

This thread is old, meanwile I have changed the CL86T to 5V DB25.

Uwe

Pls. post used g-code.

Uwe

Not sure if I remember right, but this should be fixed in current 5.1

Uwe

Yep, I also would use a small SSR, since ENA is not time critical.

Or if the drivers are enabled by default, I would skip connecting ENA, since CNC12 can force home after E-Stop but not if a single drive is disabled.

Uwe

This chart was supplied with the probe I guess? I have used some types of probes in the <200€ range and made probemaps with them. Non was as good as a KP3, but maybe ok for hobby. But for me, the most annoying thing was that none of the cheap probes stayed in center for a longer time and some of the...

Stepper with ENA from the Headers, Step/Dir from DB25

https://www.centroidcnc.com/dealersuppo ... 032.r2.pdf

Uwe