Centroid Community CNC Support Forum

Hello Everybody. I have bought several CNC systems from Ajax and they are really good. There was a few problems and I had sent a couple of boards back to Ajax and still the problem was there. On starting, the blue interface comes on and with the estop button pressed, but no error code such as "...

I have installed & checked your fast jog brain but I can't get it to work.
The fast jog LED comes on with the shift key but the axis just stops. Jog works fine otherwise in the slower mode.
I have the jog speeds set @ 5 and 100 in the Ajax plugins.
Any ideas?

I,m looking for a wiring diagram showing the 230 volt transformer. I,m cautious because I have 240 at the primary and am getting 90vac at the secondary between 1 leg and the center tap. This gives me 130vdc after the bridge. I'm only using it for servo dc supply for the ALLIN1. Also except for verif...

Sorry for the typos.
My BP conversion has been working fairly well.
However, today when I started the machine, after clicking the reset button I am constantly getting an "X axis positioning error"
Can anyone help.

Thanks,
Alex

Posts: 4
Joined: Thu Apr 01, 2010 7:26 am
Private message

My BP conversion has been working fairlt well.
However, today when I started the machine, after clicking the reset button I constintly am getting an "X axis positioning erro"
Can anyone help.

Thanks,
Alex

I'm near the finish line. himits work, M92 p# works, motors almost perfect (need help with "Z"-plot screen is different)(axis move smooth). Can't fast jog to save my life! (Ajax config- fast jog = 100, slow jog = 10,-Motor speed in "Motor Tuning"=120) The shift key lights up in t...

We are almost there in hopefully being ready to run parts Downloaded the zip file for spindle air speed increase/decrease using our 24DC valves, but don't know how to incorporate the programs or load into cnc system currently have wired as 24 vdc with your outputs from mist for mist, form Rot Clamp ...