Centroid Community CNC Support Forum

Hi Final update got the VFD working 100% I guess the 0-10VDC ports did not like a 22 AWG cable and somehow where giving me voltage drop.(if anyone can explain the reason would be much appreciated)

Changed the cable to a 16AWG and problem solved.

Hope this helps anyone.

Finally I almost have the VFD up and running it turned out to be to be the jumper that came with the unit for the VR and VI pins was broken, I soldered the jumper back and I ahve the VFD kind of working because now I can turn it on, off, reverse & forward from the software but i cant control spe...

Further update, while testing i found that the jumoer for the VI pin that came with the unit was broken, added a little bit of solder and now I have the VFD working with PD001 on 1 and PD002 on 1, but I still have one issue. When I start the centroid software I set the spindle control to 100% which ...

I have an update, got the VFD running, forward - reverse - start/stop are now working but im still no luck with the speed control. What i did is on the controller i turned the spindle on and nothing so then I wnet on to the VFD and changed PD001 and PD002 to 0 then turned PD001 back to 1 and ledt PD...

Hello I just got my Huan Yang 2.2kw VFD, I have everything connected according to the schematics and the file shared by Marty but I get no movement from the controller. I have the jumper on VI Connected all the cables to the board accordingly I am using signals VB & VC right now since I have VA...

Hello I intalled my Huan Yang 2.2kw VFD, I have everything connected according to the schematics and the file shared by Marty on other threads but I get no movement from the controller. I have the jumper on VI Connected all the cables to the board accordingly I am using signals VB & VC right now...

Hello I just got my Huan Yang 2.2kw VFD, I have everything connected according to the schematics and the file shared by Marty but I get no movement from the controller. I have the jumper on VI Connected all the cables to the board accordingly I am using signals VB & VC right now since I have VA ...

I am having the same issue, i am running 3 geckos 203v connected according to the schematics, if I connect the 5vdc all my drivers start with orange light (fault) and i get the 9031 DRIVE FAULT when I try to move any axis, when i remove the 5vdc my drivers go to green light but when i try to do any ...

Hello i just got my acorn last week and i installed everything according to the schematics, used the 220 OHM pull up resistors and wired everything accordingly. I turned on the panel tried to move my motors and got 9031 DRIVER FAULT! I went and checked my the drivers and all of them show fault orang...

Hello, I am new to the forum I am from Costa Rica and i need some help connecting my vfd to my acorn. I have checked the diagram for generic vfd but looking at mine I am not sure how to connect it. I have attached some pictures of the control ports for reference. Any help is much appreciated. Best r...