Search found 5 matches

by jsmetalcraft
Sun Dec 23, 2018 3:05 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Delta Drive Cable and Motor Brake Questions
Replies: 0
Views: 1589

Delta Drive Cable and Motor Brake Questions

A note at the bottom of the wire diagram for the communications cable it says 17 VDD +24v may be connected to COM+ instead of external supply. Do I need to add a jumper from pin 17 VDD to pin 11 COM+ on the Delta end, or does the Oak board now supply the +24v from pin 23? I want to make sure or be c...
by jsmetalcraft
Sat Dec 01, 2018 4:33 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Servo choice questions
Replies: 2
Views: 1530

Re: Servo choice questions

Thanks for the detailed answers.

-I was able to measure the lead screw and it's 12mm pitch, so good there running at rated 1500rpm or 700ipm. Rapid could be as high as 1400ipm.

-Second I was able to find detailed specifications on old servo and as thought they are rated at full speed.
by jsmetalcraft
Fri Nov 30, 2018 12:43 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Servo choice questions
Replies: 2
Views: 1530

Servo choice questions

Tired of 8k lbs of metal taking up room in shop, VMC. I have to purchase new servos to work with an Oak board. Having a budget I was looking at Delta servos. The original X-Y are 3k rpm on face plate. Having trouble to readily find the same rpm rating (C) as a commonly stocked item. Even the Yaskawa...
by jsmetalcraft
Fri Feb 09, 2018 4:17 am
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Mitshubishi Servo with Oak
Replies: 4
Views: 3530

Re: Mitshubishi Servo with Oak

Sorry for the delay. I finally was able to get the the control panel and get it open. The servo driver model is: MSD-A-SVJ-10 I have yet to determine what the drives accept for control. {D-A} 1 channel, 7bit, 0-10volt https://s3.amazonaws.com/Icarus/DOCUMENTS/Mitsubishi%5FManuals%5F3277.pdf I found ...
by jsmetalcraft
Sat Feb 03, 2018 11:01 am
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Mitshubishi Servo with Oak
Replies: 4
Views: 3530

Mitshubishi Servo with Oak

I am looking at a purchase of older machine. Want to investigate how much it would take to retrofit. I could only get to the Z servo. Was not able to get into the cabinet as another machine was pushed up against it. So not sure I am providing all the info that is needed but here it is anyway. Mitshu...