Swtiching the wires solved my problem. I am currently up and running and very appreciative of the support I have received from this forum.
Cheers.
Search found 5 matches
- Thu May 27, 2010 4:51 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: **RESOLVED** Help with runaway motors
- Replies: 6
- Views: 4852
- Thu Apr 01, 2010 1:22 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Customer First Impressions
- Replies: 12
- Views: 14889
Re: Customer First Impressions
I am using Antek toroidal transformers http://www.antekinc.com/gview.php?d[]=0 . Their range of voltages and is impressive and quite a few of them go up to 1500VA. On a related note when I was sourcing my components I read in one of the forums that having voltage output roughly 10% higher than the m...
- Tue Mar 30, 2010 1:22 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: **RESOLVED** Help with runaway motors
- Replies: 6
- Views: 4852
**RESOLVED** Help with runaway motors
With DC power removed from the contactor I have verified the limit switch functionality as well as that of the encoders by turning the shafts by hand. When I shut down the system and restart with DC power applied through the contactor, after hitting the "Reset" button in Mach3, the contact...
- Tue Mar 30, 2010 7:51 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: **RESOLVED** Mach3 Controller Spindle Bits Setup
- Replies: 2
- Views: 4191
Re: Mach3 Controller Spindle Bits Setup
I set the "spindlehighbit" to 1 (was 0) in the xml file and the error went away. Unless someone foresees this causing problems down the road, I will leave it like that.
Thanks.
Thanks.
- Mon Mar 29, 2010 1:35 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: **RESOLVED** Mach3 Controller Spindle Bits Setup
- Replies: 2
- Views: 4191
**RESOLVED** Mach3 Controller Spindle Bits Setup
I am doing initial setup of the Mach3 controller and when I start Mach3 I get a message saying "You must setup spindle bits in machajax.xml". What does this error mean and what do I need to do to fix it? I am not currently trying to control a spindle with the system, just 3 servo motors. I...