Hi Chris
Just look at Direct Automation in QLD and look for a CWC mini Contactor thay go up to 11kW
and you can buy a clip in snubber (Surge Suppressor) and thay have different coil voltages.
Graeme
Search found 7 matches
- Fri Jun 24, 2022 7:39 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Which contactor and snubber
- Replies: 27
- Views: 3727
- Sun Jun 20, 2021 6:32 am
- Forum: Centroid Acorn CNC Controller
- Topic: Hercus Turret Macro
- Replies: 48
- Views: 11679
Re: Hercus Turret Macro
Marty Thank you for all the work and all content you provide. That's what this community is all about to share our knowledge.
Upnorth I hope the information helps and works for you.
Graeme
Upnorth I hope the information helps and works for you.
Graeme
- Sat Jun 19, 2021 7:06 am
- Forum: Centroid Acorn CNC Controller
- Topic: Hercus Turret Macro
- Replies: 48
- Views: 11679
Re: Hercus Turret Macro
Hi Upnorth , I converted a Hercus PC200 to acorn about two year ago. I uses the acorn counter based tool turret with home sensor instruction to run my turret , There is no need to change the PLC as it will work as is, All that you need is to is add a single pole relay to turn the reveres voltage off...
- Thu Jan 25, 2018 5:14 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Sticky Jog Buttons
- Replies: 26
- Views: 10319
Re: Sticky Jog Buttons
Marty My Abus motinor has the same problem as Gary it happens when I in continuous and you do not have to roll or slid you finger for this to happen most of the time it is just normal touch of the button . I have not found any way to change the setting for this monitor . The other monitor (Lilliput ...
- Thu Jan 25, 2018 7:57 am
- Forum: Centroid Acorn CNC Controller
- Topic: Sticky Jog Buttons
- Replies: 26
- Views: 10319
Re: Sticky Jog Buttons
I Have Converted my Emco PC5 with acorn . While I was setting up the acorn on the bench with the lathes control panel I had the jog buttons stuck on frequently while testing . My setup is a Dell small form i5 computer and a ABUS vt168h touch monitor. I did a lot of testing on the bench and found tha...
- Tue Jan 09, 2018 6:14 am
- Forum: Centroid Acorn CNC Controller
- Topic: Acorn will not load pro license
- Replies: 4
- Views: 1622
Re: Acorn will not load pro license
Thanks Keith and Scott for the quick response, I thought the numbers did not match .
I haven't received the new license email yet.
Scott know need to apologise I understand how busy the centroid team must be.
I haven't received the new license email yet.
Scott know need to apologise I understand how busy the centroid team must be.
- Mon Jan 08, 2018 7:15 am
- Forum: Centroid Acorn CNC Controller
- Topic: Acorn will not load pro license
- Replies: 4
- Views: 1622
Acorn will not load pro license
Hi from down under (Australia) I purchased two Acorn boards in November to up date my emco PC 5 Lathe and small mill. I planed to buy all the hardware and bench test the boards before i purchased the pro license for mill and lathe. As it tuned out I decided to buy two rev 3 boards with pro mill and ...