Centroid Community CNC Support Forum

Greetings All... here's an update on our motion problem.

We put a scope on the Acorn outputs and observed a lot of noise. We swapped the 24/5VDC power supply with no effect. We worked with Joey at Centroid and arranged for a swap of the Acorn (via RMA & $200 fee). The replacement Acorn was ...

Hi Joey, and thanks for looking... yes, we completed the THC bench test. We'll gather images and post.

And thanks again for the post!!

Yes, DYN4 drives have power and light is green.

Greetings...

We have a home-brew plasma table running DMM DYN4 drives, Intel NUC running Win10 with all updates, Hypertherm 45, Acorn board circa 2018, and the new Centroid plasma kit (green board). The previous incarnation using a Proma 150 THC out of Czechoslovakia has been in service for about ...

Thanks a tonne for your input on this... Much appreciated!!

And it works as advertised; Solved our problem.

Greetings All,

I'm part of the team at BARN (Bainbridge Artisan Resource Network) in Washington State. We've built up a DIY 4'x4' CNC Plasma cutter. The torch is on Z with a Home switch and a second Height switch for setting the starting cut height (we also employ a plasma torch height controller ...

Hey Agsweeney1972,

Thanks tonnes for this post... greatly appreciated!!

David

Thanks for taking a few moments to read and reply.

I volunteer at Bainbridge Artisan Resource Network (BARN -- https://bainbridgebarn.org/) on Bainbridge Island, WA. I'm the colead of the machine shop where we are building up a DIY 4'x4' CNC Plasma cutter with an Acorn and DMM DYN4 drives & servos ...

OK. That makes sense. Thanks again!!

Ohhh... I meant to acknowledge your generous offer to help with a TV session. I did install it and was trying to get some time to get you in, but the day has not been my own. But again Keith, thanks much for your generous offer!!