Centroid Community CNC Support Forum

is there a print resource detailing changes in ver 4.14 vs 4.12?

thx

I would like to suggest consideration of G code program library for Acorn users---mill and lathe example---turning programs would include taper shank production--Morse, Jarno, B&S, and speciality--tool and cutter, etc this library would also allow new users to trial run programs for verification...

Bridgeport EZ Trak and EZ Path mill/lathe from factory 20+ years ago had a problem with lost position --dc servo- due to compression locking mechanism on smooth output shafts of SEM branded dc axis motors no key or pins or setscrews are involved in squeezing drive shaft sprocket--and under load slip...

my shop is a Lear jet hanger--26 ft ceiling no insulation no heat--burned out wood stove pipes shop temp today 40 F I run machines down to 20 F use Brayco for way lube at low temps Romi EZ Path II running on Acorn cnc 12 and manual toggle option if you use Acorn--separate DRO system is needed linked...

transformer and voltage you note should work great for Boss retrofit

fuse all applications properly and you should have a highly reliable drive system

pulsenpal

suggestions avoid delta wound transformers--the center tap neutral complicates your application toroids are great as long as you know wiring and how to handle unused leads stick with laminated core ac to ac transformers if possible toroids in preassembled form with clearly tagged leads as in your li...

the T1 transformer should work nicely for step down power input as incoming main into Leadshine drive--leave as ac voltage is my recommendation you need a 2:1 stepdown ratio with 120 vac input giving 60 vac output approximately I have used that transformer on many retrofits--20+ years ago so some sp...

MachineMaster--Slo-Motion Controls was a company two of us founded in 1990 the single focus of the company was dedicated kit retrofits of Bridgeport Boss 3 thru 6 snap in conversions eleminating all control logic boards found in the left hand-low power cabinet the step motor drives from factory rema...

the primary 3 phase transformer may present a problem regarding neutral/ground I have used the single phase step down transformer located in lower right of transformer cabinet to power step motor retrofit drives--this was 20 years ago and details are fuzzy--in those days only dc voltage input was th...

if you have balanced 3 phase input power --not static or rotary convertor-- you may be able to tap off main transformer to supply voltage range 50 to 70 vac I have not used leadshine drives, but most comparable drives have electrolytic capacitors board mounted-- this gets you around building stand a...