Centroid Community CNC Support Forum

I already sent an e-mail of the screenshot of the diagnostics screen. also attached in the email is the ajaxlog.txt. and machajax.xml we are using mach3 for the GPIO4D and MPU11 we did not connect any limit switch as of the moment because we are still testing the communication of the servo unit and ...

We have tested our GPIO4D board, and found out that our x-axis have a problem, it seems it does not give out the analog signal to the servo drive. We tested the servo unit on the Y and Z axis and it worked fine. Will it be possible to assign the Y axis as X axis and the Z axis as the Y axis? since w...

we are running on mach3 software if we connect the "servo on" and the "ground" to a source the encoders update the DRO positions on the screen. however we cannot seem to find the right connection of the servo on and ground to the GPIO4D Axis 1 from page 16 of the DA98B manual Fig...

hi i am new here. i would like to ask an assistance on how to properly connect the GPIO4D and MPU11 board to GSK DA98B servo drive. We cannot find the -10v to +10v reading on the GPIO4D board, where should we measure it? what we did was to connect the Encoder phase differential output (A,B,&Z) o...