Centroid Community CNC Support Forum

these drives should probably be connected to the DB25
do you have link to the manual for these drives?

I’d say your electrician owes you a new acorn system. The switch is maybe $20 the cost of the ether1616 board, I can understand them not wanting to break up prebuilt kits. I know it is a pain, but I’d say you need to buy an entirely new kit. The risk is that you fry each additional component you ad...

flashing (aka debricking, aka bootloader) instructions are on the Acorn start here page.
https://www.centroidcnc.com/centroid_di ... guide.html

the glue is there to stop you from plugging anything into it.

remind me did these drives have drive tuning software?

and you could try messing with delta v max but, you might be going down a rabbit hole with that one.
https://centroidcncforum.com/viewtopic. ... 707#p82707

trying a different pc is just a basic debug technique to quickly eliminate the PC as a possible source of an issue. i carry spare $150 PC's with me just for this purpose, that way i don't have to spend hours/days working on someone else's PC to try and solve an issue. :-) its probably not the PC BUT...

grassmann wrote: ↑Thu May 30, 2024 5:09 pm This is great - thank you very much. The user will have full control of the machine via another app that I am developing on top of the centroid API.
Thanks again.

can you share with us your app and its application? would be very interesting to see.

- Run the PC Tuner on the PC , and then run the stress test.
https://www.centroidcnc.com/centroid_di ... loads.html

- and make a photo album with the requested info so we can help you out.

battery type makes a difference as well. don't use rechargeable batteries.

Canned SSV has been committed and will be in the next release of CNC12 CNC12 parameters for SSV P981 : Time for Spindle Speed Variation to complete a Full Cycle in Seconds. P982 : Amount of Speed Variation (Example; S = 500, P = 100, Speed would be 400 or 600 depending on where its at in the cycle)....