Search found 3170 matches
- Tue May 07, 2024 1:29 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Touch probe
- Replies: 34
- Views: 2758
Re: Touch probe
If you are using the part setup routines, zero is set automatically (display will show 1/2 the probe value for X and Y and 0 only on Z). If you are using probe cycles (which it appears), then the part position in the current WCS is reported.
- Tue May 07, 2024 1:05 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Setting Up Allin1DC on an older 2axis Prototrak Mill
- Replies: 20
- Views: 1773
Re: Duplicate encoder Reference in Machine Parameters?
If you hardwire your machine, then it does not have to be on a GFCI circuit.
- Mon May 06, 2024 7:09 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Threading with Acorn lathe Pro
- Replies: 21
- Views: 4575
Re: Threading with Acorn lathe Pro
It's an old thread, but the information is still correct. On the thread details screen (F7) the "thread angle" setting controls how much of the cut is on the flank of the tool. Entering 60° will cut with the tip (evenly on both flanks). I usually use 55°, or 65° depending on which way I wa...
- Sat May 04, 2024 6:52 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Pro vs Ultimate, MPG questions...
- Replies: 11
- Views: 833
- Sat May 04, 2024 6:37 am
- Forum: Centroid Acorn CNC Controller
- Topic: Tool Change Macro Help
- Replies: 26
- Views: 1566
Re: Tool Change Macro Help
There's probably no need to run 100 lines of parameter checking code at every tool change. Normally, once you have your tool setter and probe set up, you never change that again.
- Fri May 03, 2024 8:53 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Tool Change Macro Help
- Replies: 26
- Views: 1566
Re: Tool Change Macro Help
You can use any tool to set your WCS Z0 as long as you ALSO have that tool's height offset active as well. If you just load the tool and not the offset, or you don't load the tool at all, then your part offset will be wrong.
- Fri May 03, 2024 4:22 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Pro vs Ultimate, MPG questions...
- Replies: 11
- Views: 833
Re: Pro vs Ultimate, MPG questions...
Pro has same CSR as ultimate. Ultimate adds scale feedback, unlimited digitizing, and lathe C axis,.
- Fri May 03, 2024 7:09 am
- Forum: Centroid Acorn CNC Controller
- Topic: C Axis Lathe Situation
- Replies: 3
- Views: 1021
- Thu May 02, 2024 2:41 pm
- Forum: Centroid Acorn CNC Controller
- Topic: CSR on acorn 5.1
- Replies: 3
- Views: 260
Re: CSR on acorn 5.1
You can select the direction for the measurement points, but the rotation symbol will always appear on the X DRO.
- Thu May 02, 2024 1:57 pm
- Forum: Centroid Acorn CNC Controller
- Topic: CSR on acorn 5.1
- Replies: 3
- Views: 260
Re: CSR on acorn 5.1
Section 4.4 in the Mill Operator's Manual.