Search found 4 matches

by Mountainman
Wed Jul 23, 2014 10:07 pm
Forum: Success Stories
Topic: completed installations
Replies: 5
Views: 6121

Re: completed installations

AMDlloydsp, what have been your negative experience with PWM servo drivers? Isn't that what the big boys use? +/-10VDC signal? I'm just learning as I go along.
by Mountainman
Wed Jul 23, 2014 8:56 pm
Forum: Centroid Community CNC Support Forum
Topic: Knee mill Low gear reversing on VFD
Replies: 8
Views: 1524

Re: Knee mill Low gear reversing on VFD

lets say that the controller knows that you are in high or low gear via the appropriate input. Where does everything go from there? If your programmed S command requires a high or low gear and your handle happens to be in the wrong position, what does the controller do? Does it stop all motion and t...
by Mountainman
Wed Sep 05, 2012 9:01 am
Forum: Centroid Community CNC Support Forum
Topic: Encoder Basics
Replies: 26
Views: 31729

Re: Encoder Basics

Anybody have clear written instructions on installing encoder to SEM servo motor. Any warning out there on what I should not do or be careful of ? I have a 1991 Bridgeport V2XT. I've seen the tutorial, but I am sure a pic means one thing to one person and something else to another.
by Mountainman
Wed Sep 05, 2012 9:01 am
Forum: Centroid Acorn CNC Controller
Topic: Encoder Basics
Replies: 43
Views: 847

Re: Encoder Basics

Anybody have clear written instructions on installing encoder to SEM servo motor. Any warning out there on what I should not do or be careful of ? I have a 1991 Bridgeport V2XT. I've seen the tutorial, but I am sure a pic means one thing to one person and something else to another.