Centroid Community CNC Support Forum

Okay, thanks.

So, just load the new job file and Cycle Start?

Is it possible to delete a current job in CNC12?
As I update my model in Fusion360 and run it again I'd rather not have multiple file names for the same job but edit in Fusion and save it as current.

Thanks.

I need to repeat a tool path drilling some holes. Seems my too offset was off and the drill bit did no go down far enough. How can I start from tool 4 in this case?

Gotcha...this helps. Thank you!

I'm using the Probe Cycle function inside of Part Setup. How are the two options you mention different?

Trying to find the part 0,0,0 on the mill. After following instructions in the manual on using the probe to find part Zero X,Y and Z, I noticed there is not option to save or accept the new values. Doe CNC 12 save these new values automatically upon cycle completion?

Suntravel, Thanks so much! I'm out to the shop this morning to setup the tool library, etc. in CNC12 then doing a test run.

Suntravel, I SEE IT NOW!!! The reference earlier to the Wizard settings is for BOTH the MPG & VCP. I also see that the INCR 1x is not 0.001" but 0.0001" and all else is a factor of that base. HOLY CRAP the light bulb just went off. I've been wondering "WTH is wrong" for over ...