Centroid Community CNC Support Forum

here is the one i got - 200$ wireless: http://www.robotdigg.com/crab/image/2023/12/06/c84ce9147b2a516819edfcd3747cba40.png Error is probably within 0.005mm, and can reach the nominal accuracy within 0.01mm (after calibration). As far as I'm aware only Renishaw does something fancy by adding strain g...

A small little update

You could use the generic china one for like 80USD that most people use in te DIY atmosphere.
Due to the technology used, they pretty much all perform the same.

The acorn is quite a good value tbh. Edingcnc starter set is also around the 360 mark. If one opts for linuxcnc and wants to use a mesa card (like most people do) you'll also quickly spend 200+ shipping + a whole lot of your time. GBRL is cheaper but also much more limited. So overall it is quite a ...

Delta C2000+ + CMC-EC01 (EtherCAT) + EMC-PG01H SIN-COS Encoder Card for the Fanuc Servo Motor: This setup adapts modern Ethercat communication to interface with the existing Fanuc servo motor. You may want to review that one with someone knowledgeable at Centroid. My understanding is that spindle d...

Hello Everyone, My name is Spikee, and I'm from the Netherlands. I've been quietly observing this forum for some time while searching for the ideal platform to base my 1992 Kitamura Mycenter Zero CNC project on. A Little Background: At the end of 2023, I finally bought a home and decided to fulfill ...

Al009 just means the position error exceeds what is set (i believe it is normally 60k pulses; look in the manual; it is some a parameter). This generally happens if the drive is not tuned and/or it is put under recessive stress where it does not have enough power to overcome that. You can monitor it...

Have you tried running the delta drive through their software? As in simple jogging etc. If that eorks you know at least the drive is working. Asdasoft also allows you to see any errors etc. Additionally it is very hard to remotly diagnose something without being provided with a step by step log of ...

Thank you. That is clear

One thing that I'm wondering. The PID (centroid side) is that purely for delay in drives or is that also a PID position-wise (running over the Delta PID)?