Centroid Community CNC Support Forum

Where do I get a copy of the file then? As I said this was a clean install in January so I would expect it just to work. If I update to the latest how do I keep all my settings?

Can anyone help with where to find the information on machine set up (turns per rev and spindle speeds) from an old CNC7 install? I think I have everything about right on the replacement Allin1DC / CNC12 install but worth checking now I managed to recover the disk. The total install is too big to at...

[Here is the report.zip

For clarification this was a fresh install from the latest CNC12 V5.10 install shield on a new PC. Neither the PLC nor the message file have been edited, o it looks like an error in the install shield.

Allin1DC with CNC12 V5.10

I installed the standard mill PLC when prompted during the install but I am getting loads of Undefined PLC messages thrown up

See picture

many thanks,

It was Parameter 411 set incorrectly

I will get a report to upload, but this is on an Allin1DC board with the latest version of CNC12 running. Initially I thought it might be related to having to reverse the motor direction on X and Z as I had not got the Y motor back in. Now I have it is the same on the Y with the motor in the normal ...

Hi, Finally made some progress on my upgrade. I got all the axis motors up and working and configured for the right directions. However using the jog buttons on the MPG-6 sends the axis in the opposite direction to the ones on the VCP. i.e. correct on VCP but inverted on MPG. I can't find any inform...

Hi, working through the bench test using the latest release of the manual and I have found an anomaly between the text and the illustration. On the Drive Bus allocation section the text says to set parameters 300, 301 and 303 i.e. skipping parameter 302, however the figure 4.1.7 shows that 300,301 a...

Many thanks Marc

HI, One of the encoders (Z axis) on the machine I am retrofitting did not work, I bought the machine as a non working one. I have fitted a new Tamagawa OIH-48, which is what the other two have been upgraded to. I tested the system today and the encoder seems to count backwards. i.e turned anti-clock...